Home › Vehicle Interior › HEATING / AIR CONDITIONING › REAR AIR CONDITIONING UNIT
RM27L0U _58 Vehicle Interior _049344 HEATING / AIR CONDITIONING _0235909 REAR AIR CONDITIONING UNIT A

HEATING / AIR CONDITIONING  REAR AIR CONDITIONING UNIT  DISASSEMBLY  


PROCEDURE

Hide 87106W 1.REMOVE REAR AIR MIX DAMPER SERVO MOTOR SUB-ASSEMBLY

a.
I104307

Disconnect the connector.


b.

Remove the 2 screws and rear air mix control servo motor.


Hide 87106X 2.REMOVE REAR MODE DAMPER SERVO MOTOR SUB-ASSEMBLY

a.
E191234

Remove the 4 screws and the bracket.


b.
I104310

Disconnect the connector.


c.

Remove the 2 screws and rear mode damper servo motor.


Hide 88710J 3.REMOVE AIRCONDITIONER CONNECTOR TUBE

a.
I104312

Remove the packing.


b.
I104313

Disconnect the hose.


c.

Remove the 3 screws.


d.
I104314

Remove the bolt and side the hook connector.


e.

Remove the air conditioning connector tube.


f.
I104316

Remove the 2 O-rings from the air conditioning connector tube.


Hide 87248 4.REMOVE WATER PIPE SUB-ASSEMBLY

a.
I104317

Remove the 4 screws and the bracket.


b.
E183739

Using pliers, grip the claws of the 2 clips and side the clips to remove the water pipe.


Hide 87245 5.REMOVE HEATER WATER INLET HOSE

a.
E183887

Using pliers, grip the claws of the clip and slide the clips to disconnect the heater water hose.


Hide 87246 6.REMOVE HEATER WATER OUTLET HOSE

a.
E183888

Using pliers, grip the claws of the clip and slide the clips to disconnect the heater water hose.


Hide 87107B 7.REMOVE HEATER RADIATOR UNIT SUB-ASSEMBLY

a.
E183889

Remove the screw.


b.

Detach the claw and remove the heater clamp.


c.
E183890

Remove the heater radiator unit from the rear cooling unit as shown in the illustration.


Hide 87103D 8.REMOVE REAR BLOWER MOTOR SUB-ASSEMBLY

a.
I104324

Remove the 3 screws and the rear blower motor.


Hide 87165C 9.REMOVE BLOWER MOTOR CONTROL

a.
I104325

Remove the 2 screws and the blower motor controller.


Hide 88515B 10.REMOVE REAR COOLING UNIT EXPANSION VALVE

a.
I104326

Detach the 3 claws and remove the plate.


b.
I104327

Remove the grommet.


c.
E150105

Using a 4 mm hexagon wrench, remove the 2 hexagon bolts and rear cooling unit expansion valve.


Hide 11.REMOVE REAR EVAPORATOR TEMPERATURE SENSOR

a.
I104328

Detach the clamp.


b.

Detach the claw and the rear evaporator temperature sensor.


Hide 88501R 12.REMOVE REAR EVAPORATOR SUB-ASSEMBLY

a.
I104329

Remove the 13 screws.


b.
I104330

Remove the rear evaporator as shown in the illustration.


c.
E150109

Remove the 2 O-rings from the rear evaporator.