Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING PRESSURE SENSOR
RM27L0U _58 Vehicle Interior _049344 HEATING / AIR CONDITIONING _0235917 AIR CONDITIONING PRESSURE SENSOR G

HEATING / AIR CONDITIONING  AIR CONDITIONING PRESSURE SENSOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 88719A 1.INSPECT AIR CONDITIONER PRESSURE SENSOR

a.

Install the manifold gauge set.

E345203E01
1.458,1.531 0.771,0.938 0.771,0.938 0.573,0.938 true 1.281,1.531 0.792,1.333 0.792,1.333 0.573,1.333 true 1.135,1.552 0.792,1.76 0.792,1.76 0.573,1.76 true 0.417,0.125 2.875,0.615 2.458,0.49 10 false Component without harness connected: (Air Conditioning Pressure Sensor) 0.385,0.833 0.542,1.031 0.156,0.198 10 false 1 0.385,1.25 0.542,1.448 0.156,0.198 10 false 2 0.385,1.656 0.542,1.854 0.156,0.198 10 false 3 4.333,0.135 6.021,0.333 1.688,0.198 10 false (V) Voltage 4.177,0.417 4.635,0.615 0.458,0.198 10 false 4.9 4.177,0.573 4.635,0.771 0.458,0.198 10 false 4.8 4.188,1.49 4.646,1.688 0.458,0.198 10 false 1.0 4.198,1.74 4.656,1.938 0.458,0.198 10 false 0.5 4.198,1.896 4.656,2.094 0.458,0.198 10 false 0.1 4.74,2.115 4.896,2.313 0.156,0.198 10 false 0 4.938,2.115 5.25,2.792 0.313,0.677 10 false 392 (4) (57) 5.781,2.115 6.146,2.792 0.365,0.677 10 false 3187 (32.5) (463) 6.417,2.125 7.063,2.646 0.646,0.521 10 false kPa (kgf/cm2) (psi) 3.323,2.365 6.385,2.563 3.063,0.198 10 false Refrigerant Pressure


b.

Disconnect the connector from the air conditioner pressure sensor.


c.

Connect the three 1.5 V dry cell batteries' positive (+) lead to terminal 3 and the negative (-) lead to terminal 1.


d.

Connect the voltmeter's positive (+) lead to terminal 2 and the negative (-) lead to terminal 1.


e.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
1 - 2 Refrigerant pressure:
392 to 3187 kPa (4 to 32.5 kgf/cm2, 57 to 463 psi)
1.0 to 4.8 V


If the result is not as specified, replace the air conditioning pressure sensor.