Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW CONTROL SYSTEM
RM27L0U _59 Vehicle Exterior _049347 WINDOW / GLASS _0235939 POWER WINDOW CONTROL SYSTEM J

WINDOW / GLASS  POWER WINDOW CONTROL SYSTEM  Auto Up Operation does not Fully Close Power Window (Jam Protection Function is Activated)  


DESCRIPTION

If the door glass or the power window regulator motor does not operate smoothly, the jam protection function may be triggered automatically, resulting in the AUTO UP function being unable to fully close the window.

PROCEDURE

1.PERFORM INITIALIZATION
a.

Initialize the power window regulator motor (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION).


b.

Check if the power window AUTO UP/DOWN function operates (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>OPERATION CHECK).

OK:

AUTO UP/DOWN function operates.




OK

END (PROBLEM DUE TO INITIALIZATION FAILURE)

NG

2.CHECK MOVEMENT OF DOOR GLASS
2.CHECK MOVEMENT OF DOOR GLASS
a.

Remove the installation bolt of the door glass and hold the glass by hand. When raising the glass by hand, check that the glass moves smoothly.

NOTICE:
·

Make sure that the door glass fits to the glass run properly.

·

Make sure that the glass run is not deformed, and does not have foreign matter.

OK:

Door glass moves smoothly.






OK

REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (APPLICABLE LOCATION)

NG

INSTALL DOOR GLASS AND/OR GLASS RUN PROPERLY