Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW CONTROL SYSTEM
RM27L0U _59 Vehicle Exterior _049347 WINDOW / GLASS _0235939 POWER WINDOW CONTROL SYSTEM C

WINDOW / GLASS  POWER WINDOW CONTROL SYSTEM  B2313  Glass Position Initialization Incomplete  


DESCRIPTION

The power window regulator motor assembly is driven by operating the power window switch. The power window regulator motor assembly has motor, regulator and ECU functions.

When the ECU determines that the power window regulator motor has not been initialized, DTC B2313 is stored.

HINT:

DTC B2311 is set when the ECU for the front door power window regulator motor assembly LH or RH malfunctions.


NOTICE:
·

When the power window regulator motor is reinstalled or replaced, the power window control system must be initialized.

·

After a door glass or a door glass run has been replaced, the jam protection function may operate unexpectedly when the auto up function is used. In such cases, the auto up function can be resumed by repeating the following operation at least 5 times:

1.

Close the power window by fully pulling up the power window switch and holding it in the auto up position.

2.

Open the power window by fully pushing down the switch.




Front Power Window Regulator Motor LH
DTC Code DTC Detection Condition Trouble Area
B2313
·

The power window regulator motor is not initialized.

·

The power window regulator motor malfunctions.


Front power window regulator motor assembly LH

Front Power Window Regulator Motor RH
DTC Code DTC Detection Condition Trouble Area
B2313
·

The power window regulator motor is not initialized.

·

The power window regulator motor malfunctions.


Front power window regulator motor assembly RH

PROCEDURE

1.PERFORM INITIALIZATION (APPLICABLE LOCATION)
a.

Initialize the power window regulator motor (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION).



NEXT

2.CHECK FOR DTC
2.CHECK FOR DTC
a.

Check for DTCs (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
B2313 is not output A
B2313 output from front power window regulator motor LH B
B2313 output from front power window regulator motor RH C



A

END

B

REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH

C

REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH