Home › Vehicle Exterior › WINDOW / GLASS › WINDSHIELD DEICER SYSTEM
RM27L0U _59 Vehicle Exterior _049347 WINDOW / GLASS _0235940 WINDSHIELD DEICER SYSTEM U

WINDOW / GLASS  WINDSHIELD DEICER SYSTEM  TERMINALS OF ECU  


CHECK AIR CONDITIONING AMPLIFIER


U153933E02
3.865,0.344 4.167,0.521 0.302,0.177 10 false H24 1.667,0.344 1.969,0.521 0.302,0.177 10 false H67 5.521,0.333 5.781,0.51 0.26,0.177 10 false z13

a.

Disconnect the H24 air conditioning amplifier connector.


b.

Measure the resistance and voltage according to the value(s) in the table below.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
H24-1 (IG+) - H24-14 (GND) P - W-B Ignition power supply Ignition switch ON 11 to 14 V
Ignition switch off Below 1 V
H24-21 (B) - H24-14 (GND) R - W-B Battery power source Always 11 to 14 V
H24-14 (GND) - Body ground W-B - Body ground Ground Always Below 1 Ω

If the result is not as specified, there may be a malfunction on the wire harness side.



c.

Reconnect the H24 air conditioning amplifier connector.


d.

Measure the voltage according to the value(s) in the table below.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
H24-37 (LIN1) - H24-14 (GND) SB - W-B LIN communication signal Ignition switch ON Pulse generation
H24-40 (D) - H24-14 (GND) GR - W-B Deicer relay Ignition switch ON
Deicer switch OFF
11 to 14 V
Ignition switch ON
Deicer switch ON
Below 1 V

If the result is not as specified, the air conditioning amplifier may have a malfunction.




CHECK INTEGRATION CONTROL AND PANEL


U153163E02
3.365,0.198 3.646,0.375 0.281,0.177 10 false H45

a.

Disconnect the H45 integration control and panel connector.


b.

Measure the resistance and voltage according to the value(s) in the table below.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
H45-16 (IG+) - H45-1 (GND) P - W-B Ignition power supply Ignition switch off Below 1 V
Ignition switch ON 11 to 14 V
H45-1 (GND) - Body ground W-B - Body ground Ground Always Below 1 Ω

If the result is not as specified, there may be a malfunction on the wire harness side.



c.

Reconnect the H45 integration control and panel connector.


d.

Measure the voltage according to the value(s) in the table below.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
H45-3 (STX) - H45-1 (GND) SB - W-B LIN communication circuit Ignition switch ON Pulse generation

If the result is not as specified, the integration control and panel may have a malfunction.