Home › Vehicle Exterior › WINDOW / GLASS › BACK DOOR POWER WINDOW SWITCH
RM27L0U _59 Vehicle Exterior _049347 WINDOW / GLASS _0235946 BACK DOOR POWER WINDOW SWITCH G

WINDOW / GLASS  BACK DOOR POWER WINDOW SWITCH  INSPECTION  


PROCEDURE

Hide 84810E 1.INSPECT BACK DOOR POWER WINDOW REGULATOR SWITCH ASSEMBLY

a.
B191732E01
0.138,0.109 2.634,0.600 2.496,0.491 10 Component without harness connected: (Back door power window regulator switch assembly)

Check the resistance.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
2 - 6
2 - 7
UP AUTO Below 1 Ω
2 - 6 UP Below 1 Ω
2 - 4 DOWN Below 1 Ω
2 - 3
2 - 4
DOWN AUTO Below 1 Ω


If the result is not as specified, replace the back door power window regulator switch.



b.

Check the illumination operation.

i.

Apply battery voltage to the back door power window regulator switch and check that the illumination comes on.

OK:
Measurement Condition Specified Condition
Battery positive (+) → Terminal 8
Battery negative (-) → Terminal 1
Illumination comes on


If the result is not as specified, replace the back door power window regulator switch.