Home › Vehicle Exterior › WINDOW / GLASS › BACK DOOR POWER WINDOW MOTOR
RM27L0U _59 Vehicle Exterior _049347 WINDOW / GLASS _0235947 BACK DOOR POWER WINDOW MOTOR G

WINDOW / GLASS  BACK DOOR POWER WINDOW MOTOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 85710G 1.INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY

a.
B164428E37
0.183,0.002 2.511,0.519 2.328,0.517 10 Component with harness connected: (Power window regulator motor assembly)

Inspect PTC operation inside the power window regulator motor.

NOTICE:

The work must be performed with the power window regulator and door glass installed on the vehicle.


i.

Connect an electrical tester DC 400 A probe to the wire harness of terminal 1.

NOTICE:

Match the arrow mark on the probe with the direction of the current flow.



ii.

Fully close the door glass by pressing the power window UP switch. Wait for approximately 60 seconds.


iii.

Continue to press the power window UP switch and measure how long it takes for the electrical current to change from a range of 16 to 28 A to approximately 1 A (Inspection of current shut-off).

Standard:

4 to 90 seconds



iv.

Check that the door glass moves downward when the power window DOWN switch is pressed.

If the result is not as specified, replace the power window regulator motor.