Home › Vehicle Exterior › SLIDING ROOF / CONVERTIBLE › SLIDING ROOF HOUSING
RM27L0U _59 Vehicle Exterior _049348 SLIDING ROOF / CONVERTIBLE _0235953 SLIDING ROOF HOUSING A

SLIDING ROOF / CONVERTIBLE  SLIDING ROOF HOUSING  DISASSEMBLY  


PROCEDURE

Hide 63245D 1.REMOVE SLIDING ROOF HOUSING REAR MOUNTING BRACKET RH

a.
B193650

Remove the 2 bolts and the rear mounting bracket.


Hide 63246D 2.REMOVE SLIDING ROOF HOUSING REAR MOUNTING BRACKET LH

HINT:

Use the same procedure for the RH side and LH side.


Hide 63260A 3.REMOVE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY

B191419

a.

Remove the 2 bolts, room light bracket and drive gear.


Hide 63306 4.REMOVE SUNSHADE TRIM SUB-ASSEMBLY

a.
B191415

Remove the screw and the sliding roof piece RH and LH.


b.
B191420

Slide and remove the sunshade trim.


Hide 63214F 5.REMOVE ROOF REAR DRIP CHANNEL

a.

Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and then slide the rear roof rear drip channel rearward to remove it.

B191418E02
5.163,0.968 6.173,1.158 1.010,0.191 10 Protective Tape 1.968,0.315 2.978,0.506 1.010,0.191 10 Protective Tape 6.165,1.052 6.264,1.052 6.264,1.052 6.464,1.861 false 1.92,0.379 1.82,0.379 1.82,0.379 1.125,0.927 false


Hide 63205A 6.REMOVE SLIDING ROOF DRIVE CABLE SUB-ASSEMBLY

NOTICE:

Do not disassemble the sliding roof drive cable sub-assembly except when replacing it.


a.
B443499E01
2.24,2.417 1.542,2.208 false 0.573,2.104 1.51,2.292 0.938,0.188 10 false Protective Tape

Using a screwdriver with its tip wrapped in protective tape, disengage the claw.


b.

Slide each roof wind deflector lifter link in the direction indicated by the arrow in the illustration to remove it.


c.

Place matchmarks on the sliding roof drive cable sub-assembly and sliding roof housing sub-assembly.


d.
B191838

Hold down the window deflector.


e.

Slide the sliding roof drive cable sub-assembly in the direction indicated by the arrow in the illustration to remove it.