Home › Vehicle Exterior › SLIDING ROOF / CONVERTIBLE › SLIDING ROOF HOUSING
RM27L0U _59 Vehicle Exterior _049348 SLIDING ROOF / CONVERTIBLE _0235953 SLIDING ROOF HOUSING A

SLIDING ROOF / CONVERTIBLE  SLIDING ROOF HOUSING  REASSEMBLY  


PROCEDURE

Hide 63205A 1.INSTALL SLIDING ROOF DRIVE CABLE SUB-ASSEMBLY

a.

Hold down the window deflector.

NOTICE:

Make sure that the spring indicated by the arrow in the illustration is securely installed.

B191422



b.

Slide the drive cable in the direction indicated by the arrow in the illustration to install it.


c.
B443500

Slide each roof wind deflector lifter link in the direction indicated by the arrow in the illustration to install it, and then engage the claw.


Hide 63205A 2.ADJUST SLIDING ROOF DRIVE CABLE SUB-ASSEMBLY

B170257E01
2.485,1.331 3.189,1.513 0.704,0.181 10 Matchmark 2.051,0.855 2.454,1.405 false

a.

Using a screwdriver with its tip wrapped in protective tape, align the matchmarks by sliding the drive cable in the directions indicated by the arrow in the illustration.


Hide 63214F 3.INSTALL ROOF REAR DRIP CHANNEL

a.

Engage the 2 claws to install the drip channel.

B191812


Hide 63306 4.INSTALL SUNSHADE TRIM SUB-ASSEMBLY

a.
B191811

Insert the sunshade trim into the sliding roof housing.


b.
B191415

Install the sliding roof piece LH and RH.


c.

Install the screw.


Hide 63260A 5.INSTALL SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY

B191419

a.

Install the drive gear and room light bracket with the 2 bolts.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


Hide 63245D 6.INSTALL SLIDING ROOF HOUSING REAR MOUNTING BRACKET RH

a.
B193650

Install the rear mounting bracket with the 2 bolts.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


Hide 63246D 7.INSTALL SLIDING ROOF HOUSING REAR MOUNTING BRACKET LH

HINT:

Use the same procedure for the RH side and LH side.