Home › Vehicle Exterior › SLIDING ROOF / CONVERTIBLE › SLIDING ROOF SWITCH ASSEMBLY
RM27L0U _59 Vehicle Exterior _049348 SLIDING ROOF / CONVERTIBLE _0235954 SLIDING ROOF SWITCH ASSEMBLY G

SLIDING ROOF / CONVERTIBLE  SLIDING ROOF SWITCH ASSEMBLY  INSPECTION  


PROCEDURE

Hide 84862 1.INSPECT SLIDING ROOF SWITCH

B167041E04
0.059,2.289 2.530,2.621 2.471,0.332 10 Component without harness connected: (Sliding Roof Switch) 1.132,3.683 0.64,3.393 false 1.404,3.769 0.781,4.207 false 2.051,3.761 2.674,4.178 false 2.265,3.786 2.822,3.404 false 1.654,3.75 1.483,4.253 false 2.86,3.323 3.074,3.463 0.214,0.140 10 UP 2.711,4.098 3.191,4.235 0.480,0.137 10 DOWN 1.249,4.253 1.741,4.415 0.491,0.163 10 CLOSE 0.369,4.124 0.706,4.277 0.337,0.154 10 OPN 0.494,3.318 0.637,3.472 0.143,0.154 10 E

a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
1 (UP) - 5 (E) TILT switch is pressed to up Below 1 Ω
1 (UP) - 5 (E) TILT switch is not pressed to up 10 kΩ or higher
2 (DOWN) - 5 (E) TILT switch is pressed to down Below 1 Ω
2 (DOWN) - 5 (E) TILT switch is not pressed to down 10 kΩ or higher
4 (OPN) - 5 (E) SLIDE switch is pressed to open Below 1 Ω
4 (OPN) - 5 (E) SLIDE switch is not pressed to open 10 kΩ or higher
3 (CLOSE) - 5 (E) SLIDE switch is pressed to close Below 1 Ω
3 (CLOSE) - 5 (E) SLIDE switch is not pressed to close 10 kΩ or higher


If the result is not as specified, replace the switch.