Home › Vehicle Exterior › DOOR / HATCH › HOOD
RM27L0U _59 Vehicle Exterior _049349 DOOR / HATCH _0235955 HOOD N

DOOR / HATCH  HOOD  ADJUSTMENT  


CAUTION / NOTICE / HINT

B057104E34
0.219,1.365 1.354,1.583 1.135,0.219 10 false Centering Bolt 2.146,1.469 3.208,1.698 1.063,0.229 10 false Standard Bolt

HINT:
·

Centering bolts are used to mount the hood hinge and hood lock. The hood and hood lock cannot be adjusted with the centering bolts in. Substitute standard bolts (with washers) for the centering bolts when making adjustments.

·

For bolts without torque specifications, check the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).



PROCEDURE

Hide 53301 1.INSPECT HOOD

a.

Check that the clearance measurements are within the standard ranges.

B190504E01
2.214,0.529 2.352,0.693 0.138,0.165 10 A 2.375,1.002 2.510,1.155 0.135,0.154 10 B

Standard:
Area Measurement Area Measurement
A 4.0 to 7.0 mm
(0.157 to 0.276 in.)
B -1.5 to 1.5 mm
(-0.059 to 0.059 in.)



Hide 53301 2.ADJUST HOOD

a.
B192131

Loosen the 4 hood side hinge bolts.


b.

Move the hood to adjust the clearance to within the standard range.


c.

Tighten the 4 hood side hinge bolts after the adjustment.

Torque:
13 N*m (133 kgf*cm, 10 ft.*lbf)


d.
B192132

Adjust the height of the hood front end by turning the cushion rubber.

HINT:

The cushion rubber can be raised and lowered by turning it.



e.

Adjust the hood lock.

i.
B192507E03
1.427,0.219 1.938,0.792 true 0.448,0.125 1.438,0.51 0.99,0.385 10 true Protective Tape

Remove the hood lock nut cap.


ii.
B192509

Loosen the 2 bolts and nut.


iii.
B166030

Adjust the hood lock position so that the striker can enter it smoothly.


iv.
B192509

Tighten the 2 bolts and nut after the adjustment.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)