Home › Vehicle Exterior › DOOR / HATCH › HOOD SUPPORT
RM27L0U _59 Vehicle Exterior _049349 DOOR / HATCH _0235956 HOOD SUPPORT A

DOOR / HATCH  HOOD SUPPORT  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:
·

As much as possible avoid touching the stroke portions of the rod to prevent foreign matter from attaching to it. Be sure to hold the cylinders while servicing.

·

Do not wear cotton gloves or other similar materials when handling the rod. Fibers may attach to the rod and result in gas leaks.

·

Do not apply any load to the cylinders in the horizontal direction in order to prevent the rod from being deformed.



HINT:
·

Use the same procedure for the RH side and LH side.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 53440B 1.INSTALL NO. 1 HOOD SUPPORT BOLT

a.

Apply adhesive to the threads of the bolt.

Adhesive:

Toyota Genuine Adhesive 1324, Three Bond 1324 or Equivalent



b.
B192128

Install the hood support bolt.

Torque:
22 N*m (224 kgf*cm, 16 ft.*lbf)

CAUTION:

Install the hood support bolt while supporting the hood by hand.



Hide 53450A 2.INSTALL HOOD SUPPORT ASSEMBLY

a.
B192130

Install the hood support assembly.

CAUTION:

Install the hood support while supporting the hood by hand.


NOTICE:

Check that the hood support is engaged in the ball joint and it cannot be pulled out.