Use the same procedure for both the RH and LH sides.
The procedure described below is for the LH side.
53450A
1.REMOVE HOOD SUPPORT ASSEMBLY
Using a screwdriver with its tip wrapped in protective tape, remove the hood support assembly while releasing the 2 clips.
Do not touch the rod of the stay with gloves, to avoid fibers from adhering.
When foreign matter adheres to the rod, it prevents the rod from moving smoothly and reduces its holding power.
Support the hood by hand while removing the hood support.
53440B
2.REMOVE NO. 1 HOOD SUPPORT BOLT
Remove the hood support bolt.