84931C
1.INSPECT BACK DOOR CONTROL SWITCH
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 5 - 8 | Pushed | Below 1 Ω |
| 5 - 8 | Free | 10 kΩ or higher |
If the result is not as specified, replace the switch.
Check the illumination operation.
Connect the positive (+) battery lead to terminal 7 (ILL+) and the negative (-) battery lead to terminal 6 (ILL-), then check that the illumination illuminates.
Illumination illuminates.
If the illumination does not illuminate, replace the back door control switch.