Home › Vehicle Exterior › DOOR / HATCH › BACK DOOR CLOSER SYSTEM
RM27L0U _59 Vehicle Exterior _049349 DOOR / HATCH _0235967 BACK DOOR CLOSER SYSTEM U

DOOR / HATCH  BACK DOOR CLOSER SYSTEM  DATA LIST / ACTIVE TEST  


DATA LIST


HINT:

Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


a.

Connect the Techstream to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the Techstream on.


d.

Enter the following menus: Body Electrical / Back Door or Back Door P/W / Data List /


e.

According to the display on the Techstream, read the Data List.

Back Door (Power Back Door ECU)
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Door Lock Status Back door lock condition signal / LOCK or UNLOCK LOCK: Back door is locked
UNLOCK: Back door is unlocked
-
Courtesy SW Back door courtesy switch signal / ON or OFF ON: Back door is open
OFF: Back door is closed
-
Closer Position SW Closer position switch signal / ON or OFF ON: Back door lock center gear is in center position
OFF: Back door lock center gear is not in center position
-
Half Latch SW Half-latch switch signal / ON or OFF ON: Back door lock motor is open-latch or over-latch
OFF: Back door lock motor is full-latch or half-latch
-

Back Door P/W (Back Door ECU)
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Key Switch Operation Locked Back door key linked switch signal / ON or OFF ON: Back door key linked switch turned to lock position
OFF: Back door key linked switch not turned
-
Key Switch Operation Unlocked Back door key linked switch signal / ON or OFF ON: Back door key linked switch turned to unlock position
OFF: Back door key linked switch not turned
-
Back Door Courtesy SW Back door courtesy switch signal / ON or OFF ON: Back door is open
OFF: Back door is closed
-
Back Door Handle Switch Back door opener switch signal / ON or OFF ON: Back door opener switch is ON
OFF: Back door opener switch is OFF
-



ACTIVE TEST


HINT:

Using the Techstream to perform Active Test allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


a.

Connect the Techstream to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the Techstream on.


d.

Enter the following menus: Body Electrical / Back Door / Active Test /


e.

According to the display on the Techstream, perform the Active Test.

Back Door (Power Back Door ECU)
Tester Display Test Part Control Range Diagnostic Note
Latch Release Power back door motor ON/OFF -