Home › Vehicle Exterior › DOOR / HATCH › POWER BACK DOOR SYSTEM
RM27L0U _59 Vehicle Exterior _049349 DOOR / HATCH _0235968 POWER BACK DOOR SYSTEM C

DOOR / HATCH  POWER BACK DOOR SYSTEM  B2222  PBD Pulse Sensor Malfunction  


DESCRIPTION

·

A pulse sensor is built into the power back door drive unit to detect foreign objects and the back door position. The pulse sensor monitors the operating speed of the back door to detect foreign objects. The pulse sensor also monitors where the back door is to detect the back door position. If a pulse signal that is out of the normal range is output, the power back door drive unit (power back door ECU) will store DTC B2222.

·

If DTC B2222 is stored, the power back door system will be turned off and the back door will be switched to manual operation mode (not electrically controlled).

·

In order to restore the power back door system to normal operation mode, first solve the problem indicated by DTC B2222 and then fully close the back door manually (reset operation).

DTC No. DTC Detection Condition Trouble Area
B2222 Power back door drive unit does not operate Power back door drive unit (Power back door ECU)


PROCEDURE

1.CLEAR DTC

NEXT

2.CHECK FOR DTC
2.CHECK FOR DTC
a.

Check for DTCs (See page Vehicle Exterior>DOOR / HATCH>POWER BACK DOOR SYSTEM>DTC CHECK / CLEAR).

OK:

DTC B2222 is not output.




OK

NG

REPLACE POWER BACK DOOR DRIVE UNIT (POWER BACK DOOR ECU)