Home › Vehicle Exterior › DOOR / HATCH › POWER BACK DOOR CONTROL SWITCH(for Driver Side)
RM27L0U _59 Vehicle Exterior _049349 DOOR / HATCH _0235970 POWER BACK DOOR CONTROL SWITCH(for Driver Side) G

DOOR / HATCH  POWER BACK DOOR CONTROL SWITCH(for Driver Side)  INSPECTION  


PROCEDURE

Hide 84931C 1.INSPECT BACK DOOR CONTROL SWITCH

a.
B192521E03
0.183,2.225 2.682,2.418 2.499,0.193 10 Component without harness connected: 0.202,2.531 1.999,2.755 1.798,0.224 10 (Back Door Control Switch) 0.429,1.281 0.776,1.450 0.347,0.169 10 Push

Inspect the resistance of the switch.

Standard Resistance:
Terminal No. Switch Condition Specified Condition
3 - 6 Free Below 1 Ω
3 - 6 Pushed 10 kΩ or higher


If the result is not as specified, replace the back door control switch.


b.
B194508E01
0.072,1.981 2.653,2.165 2.581,0.184 10 Component without harness connected: 0.084,2.228 1.811,2.453 1.727,0.224 10 (Back Door Control Switch) 1.768,3.942 2.125,4.104 0.357,0.162 10 ILL- 1.201,3.942 1.558,4.104 0.357,0.162 10 ILL+ 1.975,3.917 1.753,3.57 false 1.631,3.57 1.409,3.917 false

Check the illumination operation.

i.

Connect the positive (+) battery lead to terminal 5 (ILL+) and the negative (-) battery lead to terminal 4 (ILL-), then check that the illumination illuminates.

OK:

Illumination illuminates.


If the illumination does not illuminate, replace the back door control switch.