Home › Vehicle Exterior › MIRROR (EXT) › POWER MIRROR CONTROL SYSTEM(w/ Memory)
RM27L0U _59 Vehicle Exterior _049350 MIRROR (EXT) _0235974 POWER MIRROR CONTROL SYSTEM(w/ Memory) U

MIRROR (EXT)  POWER MIRROR CONTROL SYSTEM(w/ Memory)  TERMINALS OF ECU  


CHECK OUTER MIRROR CONTROL ECU


U153193E02
4.458,0.469 4.698,0.646 0.24,0.177 10 false M7 2.865,0.469 3.083,0.646 0.219,0.177 10 false M8

a.

Disconnect the M7 ECU connector.


b.

Measure the voltage and resistance of the wire harness side connector.

Terminal No.
(Symbol)
Wiring Color Terminal Description Condition Specified Condition
M7-3 (B) - M7-9 (GND) R - W-B Battery (ECU power source) Always 11 to 14 V
M7-4 (ACC) - M7-9 (GND) Y - W-B Ignition power supply Ignition switch LOCK Below 1 V
Ignition switch ON 11 to 14 V
M7-9 (GND) - Body ground W-B - Body ground Ground Always Below 1 Ω

If the result is not as specified, there may be a malfunction on the wire harness side.


c.

Reconnect the M7 ECU connector.


d.

Measure the voltage of the connector.

Terminal No.
(Symbol)
Wiring Color Terminal Description Condition Specified Condition
M7-1 (MR+) - M7-9 (GND) P - W-B Mirror retract motor output (retracting) Mirror retract switch ON (Outer rear view mirror LH is retracting) 11 to 14 V
M7-2 (MR-) - M7-9 (GND) V - W-B Mirror retract motor output (retracting) Mirror retract switch OFF (Outer rear view mirror LH is retracting) 11 to 14 V
M7-5 (MR+) - M7-9 (GND) LG - W-B Mirror retract motor output (retracting) Mirror retract switch ON (Outer rear view mirror RH is retracting) 11 to 14 V
M7-6 (MR-) - M7-9 (GND) BR - W-B Mirror retract motor output (retracting) Mirror retract switch OFF (Outer rear view mirror RH is retracting) 11 to 14 V
M8-2 (VC) - M8-3 (E1) LG - BR Power source for mirror position sensor Ignition switch LOCK during sleep mode Below 1 V
Ignition switch ON 3.5 to 5.5 V
M8-4 (VSR) - M8-3 (E1) L - BR Vertical direction position signal Mirror master switch R or L
Mirror control switch UP or DOWN
Voltage fluctuates between 0 and 5 V
M8-5 (HSRL) - M8-3 (E1) W - BR Horizontal direction position signal Mirror master switch R or L
Mirror control switch RIGHT or LEFT
Voltage fluctuates between 0 and 5 V
M8-18 (M+L) - M7-9 (GND) P - W-B Mirror motor output Mirror master switch L, Mirror control switch OFF Below 1 V
Mirror master switch L, Mirror control switch UP or LEFT Below 1 V
Mirror master switch L, Mirror control switch DOWN or RIGHT 11 to 14 V
M8-19 (MHL) - M7-9 (GND) B - W-B Mirror motor output Mirror master switch L, Mirror control switch OFF Below 1 V
Mirror master switch L, Mirror control switch RIGHT Below 1 V
Mirror master switch L, Mirror control switch LEFT 11 to 14 V
M8-20 (MVL) - M7-9 (GND) Y - W-B Mirror motor output Mirror master switch L, Mirror control switch OFF Below 1 V
Mirror master switch L, Mirror control switch DOWN Below 1 V
Mirror master switch L, Mirror control switch UP 11 to 14 V
M8-22 (VC) - M8-23 (E1) GR - BR Power source for mirror position sensor Ignition switch LOCK during sleep mode Below 1 V
Ignition switch ON 3.5 to 5.5 V
M8-24 (VSRR) - M8-23 (E1) P - BR Vertical direction position signal Mirror master switch R or L
Mirror control switch UP or DOWN
Voltage fluctuates between 0 and 5 V
M8-25 (HSRR) - M8-23 (E1) B - BR Horizontal direction position signal Mirror master switch R or L
Mirror control switch RIGHT or LEFT
Voltage fluctuates between 0 and 5 V
M8-36 (AR) - Body ground B - Body ground Reverse switch input Ignition switch ON, Outer mirror reverse gear link switch ON Below 1 V
Ignition switch ON, Outer mirror reverse gear link switch OFF 11 to 14 V
M8-38 (M+R) - M7-9 (GND) R - W-B Mirror motor output Mirror master switch R, Mirror control switch OFF Below 1 V
Mirror master switch R, Mirror control switch UP or LEFT Below 1 V
Mirror master switch R, Mirror control switch DOWN or RIGHT 11 to 14 V
M8-39 (MHR) - M7-9 (GND) BE - W-B Mirror motor output Mirror master switch R, Mirror control switch OFF Below 1 V
Mirror master switch R, Mirror control switch RIGHT Below 1 V
Mirror master switch R, Mirror control switch LEFT 11 to 14 V
M8-40 (MVR) - M7-9 (GND) G - W-B Mirror motor output Mirror master switch R, Mirror control switch OFF Below 1 V
Mirror master switch R, Mirror control switch DOWN Below 1 V
Mirror master switch R, Mirror control switch UP 11 to 14 V

If the result is not as specified, the ECU may have a malfunction.



CHECK MAIN BODY ECU


U153563E02
2.875,1.073 2.792,1.073 2.792,1.073 2.375,1.333 false 5.521,0.75 5.427,0.75 5.427,0.75 5.021,1 true 2.875,1.604 2.802,1.604 2.802,1.604 2.396,1.76 false 2.948,2.594 2.865,2.594 2.865,2.594 2.448,2.344 false 2.896,2.219 2.823,2.219 2.823,2.219 2.417,2.115 false 2.219,2.802 2.448,2.969 0.229,0.167 10 false DA 1.948,2.021 2.156,2.188 0.208,0.167 10 false DB 1.948,1.198 2.156,1.365 0.208,0.167 10 false DC 4.906,1.667 5.125,1.833 0.219,0.167 10 false DD 5.573,0.667 5.781,0.833 0.208,0.167 10 false DE 2.979,2.51 3.198,2.677 0.219,0.167 10 false H1 2.948,2.104 3.167,2.271 0.219,0.167 10 false H2 2.938,1.531 3.156,1.698 0.219,0.167 10 false H3 2.927,0.99 3.146,1.156 0.219,0.167 10 false H4 3.083,3.615 3.292,3.771 0.208,0.156 10 false DB 1.552,5.115 1.771,5.26 0.219,0.146 10 false DD 4.396,5.115 4.604,5.26 0.208,0.146 10 false DE 1.073,3.625 1.281,3.771 0.208,0.146 10 false DA 5.656,3.625 5.885,3.771 0.229,0.146 10 false DC 6.01,6.969 6.208,7.125 0.198,0.156 10 false H4 3.552,6.969 3.75,7.115 0.198,0.146 10 false H3 1.073,6.979 1.281,7.125 0.208,0.146 10 false H2 6.104,5.125 6.302,5.26 0.198,0.135 10 false H1

a.

Disconnect the DA and DD ECU connectors.


b.

Measure the voltage and resistance of the wire harness side connectors.

Terminal No.
(Symbol)
Wiring Color Terminal Description Condition Specified Condition
DA-1 (ALTB) - Body ground B - Body ground +B power supply Always 11 to 14 V
DD-62 (GND1, GND2) - Body ground W-B - Body ground Body ground Always Below 1 Ω

If the result is not as specified, there may be a malfunction on the wire harness side.


c.

Reconnect the DA and DD ECU connectors.


d.

Measure the voltage of the connectors.

Terminal No.
(Symbol)
Wiring Color Terminal Description Condition Specified Condition
H3-6 (RET) - DD-62 (GND1, GND2) V - W-B Mirror retract motor output (retracting) Mirror retract switch ON 11 to 14 V
H3-6 (RET) - DD-62 (GND1, GND2) V - W-B Mirror retract motor output (retracting) Mirror retract switch OFF Below 1 V
H4-11 (MIRB) - H4-2 (MIRE) R - GR Mirror motor output Mirror master switch L 11 to 14 V
Mirror master switch R 11 to 14 V
Mirror master switch OFF Below 1 V
H4-12 (MIRS) - H4-2 (MIRE) L - GR Mirror motor output Mirror master switch L, Mirror control switch RIGHT 11 to 14 V
Mirror master switch L, Mirror control switch LEFT 11 to 14 V
Mirror master switch L, Mirror control switch DOWN 11 to 14 V
Mirror master switch L, Mirror control switch UP 11 to 14 V
Mirror master switch R, Mirror control switch RIGHT 11 to 14 V
Mirror master switch R, Mirror control switch LEFT 11 to 14 V
Mirror master switch R, Mirror control switch DOWN 11 to 14 V
Mirror master switch R, Mirror control switch UP 11 to 14 V
Mirror master switch OFF Below 1 V

If the result is not as specified, the ECU may have a malfunction.