Home › Vehicle Exterior › WIPER / WASHER › WIPER AND WASHER SYSTEM
RM27L0U _59 Vehicle Exterior _049351 WIPER / WASHER _0235977 WIPER AND WASHER SYSTEM A

WIPER / WASHER  WIPER AND WASHER SYSTEM  CUSTOMIZE PARAMETERS  


PROCEDURE

Hide 1.CUSTOMIZING FUNCTION WITH TECHSTREAM (REFERENCE)

NOTICE:
·

When the customer requests a change in a function, first make sure the function(s) can be customized.

·

Be sure to make note of the current settings before customizing.

·

When troubleshooting a function, first make sure that the function is set to the default setting.



a.

Connect the Techstream to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the Techstream on.


d.

Enter the following menus: Customize Setting.


e.

Select the setting by referring to the table below.

Wiper
Display Default Content Setting
Linked Rear Wiper Washer AVAIL Function to make the rear wiper run automatically after the washer function is used. NOT AVAIL/AVAIL
Rewipe Function AVAIL Function to make the rear wiper run once automatically a certain amount of time after the washer function is completed, to prevent the dripping of washing fluid. NOT AVAIL/AVAIL