Home › Vehicle Exterior › WIPER / WASHER › FRONT WIPER MOTOR
RM27L0U _59 Vehicle Exterior _049351 WIPER / WASHER _0235978 FRONT WIPER MOTOR A

WIPER / WASHER  FRONT WIPER MOTOR  REMOVAL  


PROCEDURE

Hide 85211B 1.REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH

a.
E161312

Remove the nut and remove the wiper arm and blade assembly.


Hide 85221B 2.REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH

HINT:

Use the same procedure for both sides.


Hide 53866J 3.REMOVE FRONT FENDER TO COWL SIDE SEAL RH

a.
E161313

Disengage the claw and remove the front fender to cowl side seal.


Hide 53867H 4.REMOVE FRONT FENDER TO COWL SIDE SEAL LH

HINT:

Use the same procedure for both sides.


Hide 55781E 5.REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY

a.
E161315

Remove the 2 clips.


b.

Remove the 6 claws and 8 guides and remove the cowl top ventilator louver sub-assembly.


Hide 6.REMOVE FRONT WIPER MOTOR AND LINK ASSEMBLY

a.
E161316

Disconnect the connector.


b.

Remove the nut.


c.

Remove the 4 bolts and wiper motor and link assembly.


Hide 85110 7.REMOVE WINDSHIELD WIPER MOTOR ASSEMBLY

a.
E161317E01
1.489,1.735 2.469,1.928 0.980,0.193 10 Protective tape 1.431,1.815 1.034,0.985 false

Using a screwdriver with its tip wrapped in protective tape, disconnect the rod of the wiper link assembly from the crank arm pivot of the front wiper motor, as shown in the illustration.


b.
E161319

Put matchmarks on the crank arm and front wiper motor, as shown in the illustration.


c.

Remove the nut and remove the crank arm.


d.
E161320

Remove the 3 bolts and remove the windshield wiper motor.