Home › Vehicle Exterior › WIPER / WASHER › WASHER NOZZLE
RM27L0U _59 Vehicle Exterior _049351 WIPER / WASHER _0235983 WASHER NOZZLE G

WIPER / WASHER  WASHER NOZZLE  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 85345 1.REMOVE WASHER NOZZLE SUB-ASSEMBLY

a.

Start the engine.


b.

Check that the center stream of washer fluid sprays on the windshield within the hatched areas shown in the illustration.

Standard:

Washer fluid hits the windshield in the areas shown in the illustration.


i.

Front:

E161688E02
5.344,3.115 5.542,3.115 false 3.354,2.177 3.552,2.177 false 2.938,3.104 3.135,3.104 false 1.604,3.438 1.604,3.24 false 1.552,1.927 1.677,2.073 0.125,0.146 10 false A 3.458,2.375 3.573,2.531 0.115,0.156 10 false B 3.99,1.771 4.115,1.927 0.125,0.156 10 false C 1.198,3.427 1.969,3.635 0.771,0.208 10 false Target area 2.219,3.01 2.99,3.219 0.771,0.208 10 false Target area 2.646,2.073 3.417,2.281 0.771,0.208 10 false Target area 4.573,3.031 5.344,3.24 0.771,0.208 10 false Target area

Specification:
Area Measurement
A 124 mm
B 34.1 mm
C 96.6 mm


If the result is not as specified, replace the washer nozzle.


ii.

Rear

E209288E01
0.078,0.019 1.853,0.282 1.776,0.263 12 w/o Rear Spoiler: 0.065,2.035 1.404,2.298 1.339,0.263 12 w/ Rear Spoiler: 5.592,0.46 6.393,0.701 0.801,0.241 10 Target area 5.577,2.438 6.378,2.679 0.801,0.241 10 Target area 5.51,2.517 3.591,2.87 false 5.51,0.541 3.609,0.891 false

Specification:

Enter the target area.