Home › Vehicle Exterior › WIPER / WASHER › HEADLIGHT CLEANER SWITCH
RM27L0U _59 Vehicle Exterior _049351 WIPER / WASHER _0235985 HEADLIGHT CLEANER SWITCH G

WIPER / WASHER  HEADLIGHT CLEANER SWITCH  INSPECTION  


PROCEDURE

Hide 84150D 1.INSPECT HEAD LIGHT CLEANER SWITCH ASSEMBLY

a.
B283477E02
1.396,3.76 1.188,4.156 false 2.021,3.76 2.229,4.156 false 1.135,4.167 1.302,4.354 0.167,0.188 10 false B 0.25,2.25 2.729,2.656 2.479,0.406 10 false Component without harness connected: (Head Light Cleaner Switch) 2.24,4.167 2.406,4.354 0.167,0.188 10 false L

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
5 (L) - 8 (B) Pushed Below 1 Ω
5 (L) - 8 (B) Free 10 kΩ or higher


If the result is not as specified, replace the head light cleaner switch.


b.
B283478E01
1.607,3.839 1.401,4.234 false 1.883,3.839 2.09,4.234 false 1.261,4.268 1.579,4.455 0.318,0.187 10 ILL+ 0.225,2.24 2.703,2.648 2.479,0.408 10 Component without harness connected: (Head Light Cleaner Switch) 2.02,4.268 2.411,4.455 0.391,0.187 10 ILL-

Check the illumination operation.

i.

Connect the positive (+) battery lead to terminal 7 (ILL+) and the negative (-) battery lead to terminal 6 (ILL-), and then check that the illumination illuminates.

OK:

Illumination illuminates.


If the illumination does not illuminate, replace the head light cleaner switch.