Home › Vehicle Exterior › WIPER / WASHER › RELAY
RM27L0U _59 Vehicle Exterior _049351 WIPER / WASHER _0235987 RELAY G

WIPER / WASHER  RELAY  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 85942 1.INSPECT HEADLIGHT CLEANER CONTROL RELAY

a.
E345008E01
2.104,2.698 2.344,2.906 false 1.313,2.708 1.083,2.969 false 1.281,2.125 0.969,1.927 false 1.677,2.094 1.677,1.604 1.677,1.604 1.74,1.604 false 0.323,0.125 2.74,0.521 2.417,0.396 10 false Component without harness connected: (Headlight Cleaner Control Relay) 2.396,2.896 2.552,3.094 0.156,0.198 10 false E 0.927,2.979 1.24,3.177 0.313,0.198 10 false PB 0.802,1.833 1.115,2.031 0.313,0.198 10 false IG 1.792,1.521 1.948,1.719 0.156,0.198 10 false H

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
6 (PB)- 4 (E) When battery voltage is not applied between terminals 3 (IG) and 2 (H) 10 kΩ or higher
When battery voltage is applied between terminals 3 (IG) and 2 (H) Below 1 Ω (0.8 to 0.9 seconds, then no continuity exists)


If the result is not as specified, replace the headlight cleaner control relay.