1. CUSTOMIZING FUNCTION WITH TECHSTREAM
The following items can be customized.
When the customer requests a change in a function, first make sure that the function can be customized.
Be sure to make a note of the current settings before customizing.
When troubleshooting a function, first make sure that the function is set to the default setting.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Customize Setting.
Select the setting by referring to the table below.
| Display | Default | Content | Setting |
|---|---|---|---|
| Light Auto OFF Delay | 30s | Function to continue illuminating headlight for certain period of time after closing all doors with ignition switch turned from ON to OFF under condition that light control switch is at HEAD or AUTO with the headlight ON | OFF/30s/60s/90s |
| Sensitivity | NORMAL | Function to adjust ambient light sensitivity of automatic light control system*1 | Light2/Light1/Normal/Dark1/Dark2 |
The sensitivity adjustment may be difficult to confirm. Check by driving the customer's vehicle.
When the setting is closer to the "Light" side, the system turns the lights on even when the surrounding area is relatively bright. When the setting is closer to the "Dark" side, the system waits until the surrounding area is darker before turning on the lights.
| Display | Default | Content | Setting |
|---|---|---|---|
| Foot Light | 30s | Changes illumination duration after door closure | OFF/7.5s/15s/30s |