Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT DIMMER SWITCH
RM27L0U _59 Vehicle Exterior _049352 LIGHTING (EXT) _0235997 HEADLIGHT DIMMER SWITCH G

LIGHTING (EXT)  HEADLIGHT DIMMER SWITCH  INSPECTION  


PROCEDURE

Hide 84140 1.INSPECT HEADLIGHT DIMMER SWITCH ASSEMBLY

a.

Check the resistance of the light control switch.

i.
E146065E04
2.417,2.073 2.896,2.073 true 2.271,2.115 2.906,2.552 true 2.115,2.115 2.625,2.688 true 1.948,2.115 2.198,2.615 true 1.792,2.115 1.99,2.865 true 1.646,2.115 1.635,2.594 true 1.5,2.115 1.365,2.896 true 1.354,2.115 1.01,2.698 true 1.198,2.115 0.677,2.583 true 0.521,2.073 1,2.073 true 2.104,1.865 2.469,1.219 true 1.948,1.875 1.583,1.219 true 0.302,0.115 2.604,0.479 2.302,0.365 10 false Component with harness connected: (Headlight Dimmer Switch) 0.333,1.99 0.479,2.146 0.146,0.156 10 false H 0.51,2.542 0.667,2.719 0.156,0.177 10 false A 0.927,2.75 1.083,2.927 0.156,0.177 10 false T 2.958,2.49 3.146,2.667 0.188,0.177 10 false EL 1.24,2.927 1.438,3.104 0.198,0.177 10 false HF 1.531,2.625 1.729,2.802 0.198,0.177 10 false HL 1.906,2.896 2.083,3.073 0.177,0.177 10 false TL 2.104,2.625 2.323,2.802 0.219,0.177 10 false CR 2.531,2.729 2.729,2.906 0.198,0.177 10 false TR 2.958,1.979 3.177,2.156 0.219,0.177 10 false HU 1.292,1.083 1.594,1.26 0.302,0.177 10 false BFG 2.521,1.073 2.813,1.25 0.292,0.177 10 false LFG

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
12 (EL) - 18 (T) TAIL Below 1 Ω
12 (EL) - 18 (T) HEAD Below 1 Ω
12 (EL) - 20 (H) HEAD Below 1 Ω
12 (EL) - 19 (A) AUTO Below 1 Ω


If the result is not as specified, replace the headlight dimmer switch.



b.

Check the resistance of the headlight dimmer switch.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
11 (HU) - 12 (EL) FLASH Below 1 Ω
17 (HF) - 12 (EL) FLASH Below 1 Ω
16 (HL) - 12 (EL) LOW BEAM Below 1 Ω
11 (HU) - 12 (EL) HI BEAM Below 1 Ω


If the result is not as specified, replace the headlight dimmer switch.



c.

Check the resistance of the turn signal switch.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
12 (EL) - 13 (TR) Right turn Below 1 Ω
12 (EL) - 13 (TR)
12 (EL) - 15 (TL)
Neutral 10 kΩ or higher
12 (EL) - 15 (TL) Left turn Below 1 Ω


If the result is not as specified, replace the headlight dimmer switch.



d.

Check the resistance of the fog light switch.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
3 (LFG) - 4 (BFG) ON Below 1 Ω
3 (LFG) - 4 (BFG) OFF 10 kΩ or higher


If the result is not as specified, replace the headlight dimmer switch.