Home › Vehicle Exterior › LIGHTING (EXT) › STOP LIGHT SWITCH
RM27L0U _59 Vehicle Exterior _049352 LIGHTING (EXT) _0235998 STOP LIGHT SWITCH A

LIGHTING (EXT)  STOP LIGHT SWITCH  INSTALLATION  


PROCEDURE

Hide 84340 1.INSTALL STOP LIGHT SWITCH ASSEMBLY

F049043E31
2.24,1.365 2.052,1.74 false 1.208,1.25 1.448,1.375 false 0.583,1.198 0.521,1.365 false 1.219,1.417 1.771,1.615 0.552,0.198 10 false Adjuster 0.052,1.396 0.844,1.573 0.792,0.177 10 false Brake Pedal 1.552,1.781 2.667,1.969 1.115,0.188 10 false Stop Light Switch

a.

Install the stop light switch into the adjuster until it slightly touches the brake pedal.

NOTICE:

Do not depress the brake pedal.


i.
F049044E49
1.854,1.25 1.938,1.365 false 0.563,0.708 0.51,0.229 true 0.167,0.094 1.125,0.396 0.958,0.302 10 false Shaft 1.302,1.375 2.406,1.583 1.104,0.208 10 false Stop Light Switch 0.104,1.729 1.156,1.917 1.052,0.188 10 false 0.5 to 2.6 mm

Make a quarter turn clockwise to install the stop light switch.

NOTICE:

Do not depress the brake pedal.


HINT:

Do not tighten the stop light switch more than the torque specification.


Torque:
1.5 N*m (15 kgf*cm, 13 in.*lbf)



b.

Check the stop light switch clearance.

Stop light switch clearance:

0.5 to 2.6 mm (0.020 to 0.102 in.)



c.

Connect the stop light switch connector to the stop light switch.