Home › Vehicle Exterior › LIGHTING (EXT) › STOP LIGHT SWITCH
RM27L0U _59 Vehicle Exterior _049352 LIGHTING (EXT) _0235998 STOP LIGHT SWITCH G

LIGHTING (EXT)  STOP LIGHT SWITCH  INSPECTION  


PROCEDURE

Hide 84340 1.INSPECT STOP LIGHT SWITCH ASSEMBLY

a.

Measure the resistance according to the value(s) in the table below.

E344953E01
1.177,2.01 1.75,2.219 0.573,0.208 10 false Pushed 0.927,2.302 1.875,2.5 0.948,0.198 10 false Not Pushed 4.083,0.271 6.521,0.781 2.438,0.51 10 false Component without harness connected: (Stop Light Switch)

Standard Resistance:
Tester Connection Switch Condition Specified Condition
1 - 2 Pushed 10 kΩ or higher
Not pushed Below 1 Ω
3 - 4 Pushed Below 1 Ω
Not pushed 10 kΩ or higher


If the result is not as specified, replace the switch assembly.