Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC LIGHT CONTROL SENSOR
RM27L0U _59 Vehicle Exterior _049352 LIGHTING (EXT) _0235999 AUTOMATIC LIGHT CONTROL SENSOR G

LIGHTING (EXT)  AUTOMATIC LIGHT CONTROL SENSOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 89120 1.INSPECT AUTOMATIC LIGHT CONTROL SENSOR

a.
U153963E01
0.18,0.259 2.670,0.628 2.489,0.369 10 Component with harness connected: (Automatic Light Control Sensor) 0.616,2.025 0.880,2.207 0.264,0.181 10 I21 0.527,2.637 0.917,2.800 0.390,0.163 10 CLTB 2.466,1.853 2.879,2.016 0.413,0.163 10 CLTE 2.466,2.333 2.861,2.496 0.394,0.163 10 CLTS 2.432,2.425 1.939,2.425 false 1.929,2.201 2.406,1.952 false 1.024,2.734 1.501,2.485 false

Check the power source circuit and ground circuit.

i.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
I21-6 (CLTB) - I21-3 (CLTE) Ignition switch ON 11 to 14 V



ii.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
I21-3 (CLTE) - Body ground Always Below 1 Ω




b.

Check the waveform.

i.
E163473E01
2.926,0.925 3.256,1.074 0.330,0.149 10 GND 1.819,1.29 1.944,1.439 0.125,0.149 10 A

Check the waveform according to the value(s) in the table below.

Standard Waveform:
Tester Connection Tool Setting Switch Condition Specified Condition
I21-3 (CLTE) - I21-5 (CLTS) 5 V/DIV., 5 msec./ DIV. Ignition switch ON, Headlight dimmer switch AUTO Correct waveform is as shown


HINT:

If the ambient light becomes brighter, width A becomes narrower.

If the result is not as specified, replace the automatic light control sensor.