85926
1.INSPECT HEADLIGHT DIMMER RELAY
Check the resistance.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3 - 5 | When battery voltage not applied | 10 kΩ or higher |
| 3 - 5 | When battery voltage to terminals 1 and 2 | Below 1 Ω |
If the result is not as specified, replace the headlight dimmer relay.
85916P
2.INSPECT HEADLIGHT RELAY
Check the resistance.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3 - 5 | When battery voltage not applied | 10 kΩ or higher |
| 3 - 5 | When battery voltage to terminals 1 and 2 | Below 1 Ω |
If the result is not as specified, replace the headlight relay.
85916D
3.INSPECT FOG LIGHT RELAY
Check the resistance.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3 - 5 | When battery voltage not applied | 10 kΩ or higher |
| 3 - 5 | Apply battery voltage to terminals 1 and 2 | Below 1 Ω |
If the result is not as specified, replace the fog light relay.
85916Y
4.INSPECT TOWING TAIL RELAY
Check the resistance.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3 - 5 | When battery voltage not applied | 10 kΩ or higher |
| 3 - 5 | Apply battery voltage to terminals 1 and 2 | Below 1 Ω |
If the result is not as specified, replace the towing tail relay.