Home › Vehicle Exterior › LIGHTING (EXT) › HAZARD WARNING SWITCH
RM27L0U _59 Vehicle Exterior _049352 LIGHTING (EXT) _0236003 HAZARD WARNING SWITCH G

LIGHTING (EXT)  HAZARD WARNING SWITCH  INSPECTION  


PROCEDURE

Hide 84330 1.INSPECT HAZARD WARNING SWITCH

E136319E02
0.068,0 2.755,0.387 2.686,0.387 10 Component without harness connected: (Hazard Warning Signal Switch Assembly)

a.

Check the resistance.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
1 - 4 OFF 10 kΩ or higher
1 - 4 ON Below 1 Ω


If the result is not as specified, replace the hazard warning signal switch.



b.

Check the illumination operation.

i.

Connect the positive (+) battery lead to terminal 3 and the negative (-) battery lead to terminal 2, and then check that the illumination illuminates.

OK:

Illumination illuminates.


If the illumination does not illuminate, replace the hazard warning signal switch.