Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT BUMPER
RM27L0U _59 Vehicle Exterior _049355 EXTERIOR PANELS / TRIM _0236009 FRONT BUMPER A

EXTERIOR PANELS / TRIM  FRONT BUMPER  INSTALLATION  


PROCEDURE

Hide 52119A 1.INSTALL FRONT BUMPER COVER

a.

Connect the connectors.

HINT:

This procedure is only necessary for vehicles equipped with fog lights or the intuitive parking assist system.



b.
B194114

Attach the 4 claws to install the front bumper cover.


c.
B220208E03
0.781,4.229 0.948,4.396 0.167,0.167 10 true A 1.302,4.24 1.458,4.406 0.156,0.167 10 true A 1.667,4.208 1.823,4.375 0.156,0.167 10 true A 2.073,4.229 2.25,4.406 0.177,0.177 10 true A 2.583,4.229 2.76,4.417 0.177,0.188 10 true A

Install the 8 clips.


d.

Install the 7 screws.

Torque:
for screws labeled A : 3.0 N*m (31 kgf*cm, 27 in.*lbf)


e.
B231445

Install the 2 pin hold clips so that their grooves are vertical.

HINT:

Use the same procedure for the RH side and LH side.



f.

Install the clip.

HINT:

Use the same procedure for the RH side and LH side.



g.

Install the screw.

HINT:

Use the same procedure for the RH side and LH side.



Hide 53932B 2.INSTALL FRONT END PANEL LH (w/o Headlight Cleaner System)

Hide 53931B 3.INSTALL FRONT END PANEL RH (w/o Headlight Cleaner System)

HINT:

Use the same procedure described for the LH side.


Hide 53932B 4.INSTALL FRONT END PANEL LH (w/ Headlight Cleaner System)

Hide 53931B 5.INSTALL FRONT END PANEL RH (w/ Headlight Cleaner System)

HINT:

Use the same procedure described for the LH side.


Hide 6.PREPARE VEHICLE FOR HEADLIGHT AIMING ADJUSTMENT

Hide 7.PREPARE FOR HEADLIGHT AIMING (for Using a Tester)

Hide 8.PREPARE FOR HEADLIGHT AIMING (for Using a Screen)

Hide 11.PREPARE VEHICLE FOR FOG LIGHT AIMING ADJUSTMENT (w/ Fog Light)

Hide 12.PREPARE FOR FOG LIGHT AIMING (w/ Fog Light)

Hide 13.INSPECT FOG LIGHT AIMING (w/ Fog Light)

Hide 14.ADJUST FOG LIGHT AIMING (w/ Fog Light)