Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR BUMPER
RM27L0U _59 Vehicle Exterior _049355 EXTERIOR PANELS / TRIM _0236010 REAR BUMPER A

EXTERIOR PANELS / TRIM  REAR BUMPER  INSTALLATION  


PROCEDURE

Hide 52159 1.INSTALL REAR BUMPER COVER

B191656

a.

Engage the 12 claws and install the rear bumper cover.


b.
B195443

Engage the 2 harness clamps and connect the connector.


c.
B191655E03
1.344,1 1.344,0.708 false 2.875,0.583 2.875,0.292 false 1.344,0.708 2.875,0.292 false 1.615,1 1.615,0.635 false 1.917,0.917 1.917,0.552 false 2.281,0.823 2.281,0.448 false 2.594,0.74 2.594,0.375 false 2.063,0.51 2,0.156 false 2,0.156 1.823,0.156 false 2.573,2.656 3.125,2.656 false 3.125,2.656 3.042,3.458 false 2.771,3.25 2.844,2.656 false 0.51,3.26 0.917,3.5 0.406,0.24 10 true Screw 1.448,3.427 1.75,3.646 0.302,0.219 10 true Bolt 2.292,4.167 2.698,4.406 0.406,0.24 10 true Screw 2.219,3.792 2.521,4.01 0.302,0.219 10 true Bolt 1.51,0.073 1.813,0.292 0.302,0.219 10 false Bolt 2.25,2.563 2.604,2.75 0.354,0.188 10 false Clip

Tighten the 6 bolts for upper side of the rear bumper cover.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


d.

Tighten the 2 bolts for lower side of the rear bumper cover.

Torque:
9.0 N*m (92 kgf*cm, 80 in.*lbf)


e.

Tighten the 2 screws and install the 2 clips.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


Hide 76626E 2.INSTALL REAR QUARTER PANEL MUDGUARD LH

B191653

a.

Install the rear quarter panel mudguard with the 9 screws and clip.


Hide 76625G 3.INSTALL REAR QUARTER PANEL MUDGUARD RH

HINT:

Use the same procedure as for the LH side.