Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › ROOF DRIP SIDE FINISH MOULDING
RM27L0U _59 Vehicle Exterior _049355 EXTERIOR PANELS / TRIM _0236020 ROOF DRIP SIDE FINISH MOULDING A

EXTERIOR PANELS / TRIM  ROOF DRIP SIDE FINISH MOULDING  INSTALLATION  


PROCEDURE

Hide 75561A 1.INSTALL ROOF DRIP SIDE FINISH MOULDING CLIP

B191711E01
0.555,0.197 0.655,0.381 0.100,0.184 10 a 1.895,0.936 2.010,1.120 0.114,0.184 10 b 0.537,3.463 0.638,3.633 0.100,0.170 10 c 1.741,4.15 1.869,4.320 0.128,0.170 10 d

NOTICE:

Only follow this procedure when replacing the clips.


a.

Remove the tape that remains on the moulding surface of the vehicle body, and then clean the surface with a non-residue solvent.


b.

Using an infrared light, heat the clip installation surface on the vehicle body and roof drip side finish moulding.

Heating Temperature:
Area Temperature
Vehicle Body 40 to 60°C (104 to 140°F)
Roof Drip Side Finish Moulding 20 to 30°C (68 to 86°F)


NOTICE:

Do not excessively heat the vehicle body or roof drip side finish moulding.



c.

Install new clips in the positions shown in the illustration. Press in the clips by hand.

Specification:
Area Measurement
a 4.7 mm (0.185 in.)
b 5.1 mm (0.201 in.)
c 4.7 mm (0.185 in.)
d 5.0 mm (0.197 in.)


NOTICE:

After pressing in the clips, wait 30 minutes or more before installing the roof drip side finish moulding.


HINT:
·

Minimum hardening time: 30 minutes

·

Time needed for complete hardening: 24 hours




Hide 75552 2.INSTALL ROOF DRIP SIDE FINISH MOULDING

a.
B191710

Engage the 2 clips and install the roof drip side finish moulding.


b.

Remove the protective tape.