EVAP
Monitor ID
| Test ID
| Scaling
| Unit
| Description
|
$3D
| $C9
| Multiply by 0.001
| kPa
| Test value for small leak (P0456)
|
$3D
| $CA
| Multiply by 0.001
| kPa
| Test value for gross leak (P0455)
|
$3D
| $CB
| Multiply by 0.001
| kPa
| Test value for leak detection pump OFF stuck (P2401)
|
$3D
| $CD
| Multiply by 0.001
| kPa
| Test value for leak detection pump ON stuck (P2402)
|
$3D
| $CE
| Multiply by 0.001
| kPa
| Test value for vent valve OFF stuck (P2420)
|
$3D
| $CF
| Multiply by 0.001
| kPa
| Test value for vent valve ON stuck (P2419)
|
$3D
| $D0
| Multiply by 0.001
| kPa
| Test value for reference orifice low flow (P043E)
|
$3D
| $D1
| Multiply by 0.001
| kPa
| Test value for reference orifice high flow (P043F)
|
$3D
| $D4
| Multiply by 0.001
| kPa
| Test value for purge VSV close stuck (P0441)
|
$3D
| $D5
| Multiply by 0.001
| kPa
| Test value for purge VSV open stuck (P0441)
|
$3D
| $D7
| Multiply by 0.001
| kPa
| Test value for purge flow insufficient (P0441)
|
Misfire
Monitor ID
| Test ID
| Scaling
| Unit
| Description
|
$A1
| $0B
| Multiply by 1
| Time
| Total EWMA misfire count of all cylinders in last ten driving cycles EWMA: Exponential Weighted Moving Average
|
$A1
| $0C
| Multiply by 1
| Time
| - When ignition switch is ON, total misfire count of all cylinders in last driving cycle is displayed.
- While engine is running, total misfire count of all cylinders in current driving cycle is displayed.
|
$A2
| $0B
| Multiply by 1
| Time
| Total EWMA misfire count of cylinder 1 in last ten driving cycles
|
$A2
| $0C
| Multiply by 1
| Time
| - When ignition switch is ON, total misfire count of cylinder 1 in last driving cycle is displayed.
- While engine is running, total misfire count of cylinder 1 in current driving cycle is displayed.
|
$A3
| $0B
| Multiply by 1
| Time
| Total EWMA misfire count of cylinder 2 in last ten driving cycles
|
$A3
| $0C
| Multiply by 1
| Time
| - When ignition switch is ON, total misfire count of cylinder 2 in last driving cycle is displayed.
- While engine is running, total misfire count of cylinder 2 in current driving cycle is displayed.
|
$A4
| $0B
| Multiply by 1
| Time
| Total EWMA misfire count of cylinder 3 in last ten driving cycles
|
$A4
| $0C
| Multiply by 1
| Time
| - When ignition switch is ON, total misfire count of cylinder 3 in last driving cycle is displayed.
- While engine is running, total misfire count of cylinder 3 in current driving cycle is displayed.
|
$A5
| $0B
| Multiply by 1
| Time
| Total EWMA misfire count of cylinder 4 in last ten driving cycles
|
$A5
| $0C
| Multiply by 1
| Time
| - When ignition switch is ON, total misfire count of cylinder 4 in last driving cycle is displayed.
- While engine is running, total misfire count of cylinder 4 in current driving cycle is displayed.
|
$A6
| $0B
| Multiply by 1
| Time
| Total EWMA misfire count of cylinder 5 in last ten driving cycles
|
$A6
| $0C
| Multiply by 1
| Time
| - When ignition switch is ON, total misfire count of cylinder 5 in last driving cycle is displayed.
- While engine is running, total misfire count of cylinder 5 in current driving cycle is displayed.
|
$A7
| $0B
| Multiply by 1
| Time
| Total EWMA misfire count of cylinder 6 in last ten driving cycles
|
$A7
| $0C
| Multiply by 1
| Time
| - When ignition switch is ON, total misfire count of cylinder 6in last driving cycle is displayed.
- While engine is running, total misfire count of cylinder 6 in current driving cycle is displayed.
|