Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING SYSTEM

DTC    C2174/74    Vehicle Speed Signal Malfunction

DTC    C2191/91    Vehicle Speed Signal Error (Test Mode DTC)

for Preparation Click here


DESCRIPTION

The tire pressure warning ECU receives a speed signal from the combination meter. This DTC is stored upon entering test mode, and cleared when a vehicle speed signal of 20 km/h (12 mph) is detected for 3 seconds or more. This DTC is output only in test mode.

DTC Code
Detection Condition
Trouble Area
C2174/74
Vehicle speed signal malfunction
  1. Combination meter
  2. Harness or connector
  3. Vehicle speed signal circuit
  4. Tire pressure warning ECU
C2191/91
Test mode procedure is performed
  1. Combination meter
  2. Harness or connector
  3. Vehicle speed signal circuit
  4. Tire pressure warning ECU

WIRING DIAGRAM


C174781E03


INSPECTION PROCEDURE

NOTICE:
  1. When replacing the tire pressure warning ECU, read the transmitter IDs stored in the old ECU using Techstream and write them down before removal.
  2. It is necessary to perform initialization (Click here) after registration (Click here) of the transmitter IDs into the tire pressure warning ECU after the ECU and/or tire pressure warning valve and transmitter has been replaced.

1.READ VALUE USING DATA LIST (VEHICLE SPEED)
  1. Turn the ignition switch OFF.

  1. Connect Techstream to the DLC3.

  1. Turn the ignition switch ON and the tester ON.

  1. Enter the following menus: Chassis / Tire Pressure Monitor / Data List.

  1. Check that the values indicated on the tester and on the combination meter are the same.

    Tire Pressure Monitor 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Vehicle Speed
    Vehicle speed/
    min.: 0 km/h (0 mph)
    max.: 255 km/h (158 mph)
    Almost same as actual vehicle speed
    Speed indicated on combination meter

    OK:
    Vehicle speed indicated on the Techstream indicates the actual speed.

    Result 
    Result
    Proceed to
    NG
    A
    OK
    B



B
USE SIMULATION METHOD TO CHECK (Click here)
A


2.CHECK HARNESS AND CONNECTOR (ECU - COMBINATION METER)
  1. Disconnect the T15 ECU connector.



    C158878E05
  1. Disconnect the C10 meter connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    T15-2 (SPD) - C10-36 (+S)
    Always
    Below 1 Ω
    T15-2 (SPD) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

GO TO METER / GAUGE SYSTEM (Click here)