ANTI-LOCK BRAKE SYSTEM > ABS Warning Light does not Come ON |
| 1.INSPECT ABS WARNING LIGHT |
Disconnect the skid control ECU connector.
Turn the ignition switch to the ON position.
Check that the ABS warning light comes on.
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (BETWEEN SKID CONTROL ECU AND COMBINATION METER ASSEMBLY) |
![]() |
Turn the ignition switch off.
Disconnect the combination meter connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Specified Condition |
| S3-30 (WA) - C10-7 | Below 1 Ω |
| S3-30 (WA) - Body ground | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.INSPECT COMBINATION METER ASSEMBLY |
Check the combination meter (Click here).
|
| ||||
| OK | ||
| ||