Anti-lock Brake System:
Symptom
| Suspected Area
| See page
|
ABS does not operate
| 1. Check the DTC again and make sure that the normal system code is output.
|
Click here
|
2. IG power source circuit
|
Click here
|
3. Front speed sensor circuit
|
Click here
|
4. Rear speed sensor circuit
|
Click here
|
5. Check the brake actuator with Techstream. If abnormal, check the hydraulic circuit for leakage.
|
Click here
|
6. If the symptoms still occur even after the above circuits in suspected areas have been inspected and proved to be normal, replace the brake actuator assembly.
|
Click here
|
ABS does not operate efficiently
| 1. Check the DTC again and make sure that the normal system code is output.
|
Click here
|
2. Front speed sensor circuit
|
Click here
|
3. Rear speed sensor circuit
|
Click here
|
4. Stop light switch circuit
|
Click here
|
5. Check the brake actuator with Techstream. If abnormal, check that hydraulic circuit for leakage.
|
Click here
|
6. If the symptoms still occur even after the above circuits in suspected areas have been inspected and proved to be normal, replace the brake actuator assembly.
|
Click here
|
ABS warning light abnormal (Remains on)
| 1. ABS warning light circuit
|
Click here
|
2. Brake actuator assembly
|
Click here
|
ABS warning light abnormal (Does not come on)
| 1. ABS warning light circuit
|
Click here
|
2. Brake actuator assembly
|
Click here
|
BRAKE warning light abnormal (Remains on)
| 1. BRAKE warning light circuit
|
Click here
|
2. Brake actuator assembly
|
Click here
|
BRAKE warning light abnormal (Does not come on)
| 1. BRAKE warning light circuit
|
Click here
|
2. Brake actuator assembly
|
Click here
|
DTC check cannot be done
| 1. Check the DTC again and make sure that the normal system code is output.
|
Click here
|
2. TC and CG terminal circuit
|
Click here
|
3. If the symptoms still occur even after the above circuits in suspected areas have been inspected and proved to be normal, replace the brake actuator assembly.
|
Click here
|
Test mode (Signal check) cannot be done
| 1. TS and CG terminal circuit
|
Click here
|
2. Brake actuator assembly
|
Click here
|