AUTOMATIC TRANSAXLE ASSEMBLY > INSTALLATION |
| 1. INSTALL TORQUE CONVERTER CLUTCH ASSEMBLY |
Install the torque converter clutch to the automatic transaxle.
![]() |
Using a vernier caliper and a straightedge, measure dimension A between the transaxle fitting surface of the engine *1 and the converter fitting surface of the drive plate *2. (#)
![]() |
Using a vernier caliper and a straight edge, measure dimension B shown in the illustration and check that B is greater than A (measured in step (#)).
| 2. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY |
![]() |
Install the automatic transaxle to the engine with the 10 bolts.
Apply a few drops of adhesive to each of 2 threads on the tip of the 6 torque converter clutch mounting bolts.
![]() |
Install the 6 torque converter clutch mounting bolts.
![]() |
Install the flywheel housing under cover to the automatic transaxle with the 2 bolt.
| 3. INSTALL ENGINE MOUNTING BRACKET FRONT |
![]() |
Install the engine mounting bracket front to the automatic transaxle with the 3 bolts.
| 4. INSTALL TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY |
Coat a new O-ring with ATF, and install it to the transmission oil filler tube sub-assembly.
![]() |
Install the transmission oil filler tube sub-assembly and bolt to the automatic transaxle.
Connect the 2 clamps to the oil filler tube.
Install the ATF level gauge.
| 5. INSTALL OIL COOLER INLET TUBE NO.1 |
Temporarily install the oil cooler outlet tube No.1.
Temporarily install the oil cooler inlet tube No.1.
![]() |
Install the oil cooler tube clamp and bolt.
![]() |
Using SST and a wrench, tighten the oil cooler inlet tube No.1.
| 6. INSTALL OIL COOLER OUTLET TUBE NO.1 |
Using SST and a wrench, tighten the oil cooler outlet tube No.1.
| 7. INSTALL TRANSMISSION CONTROL CABLE BRACKET NO.1 |
![]() |
Install the control cable bracket No.1 with the 2 bolts.
| 8. CONNECT CONNECTORS |
![]() |
Connect the transmission wire connector.
Connect the park/neutral position switch connector.
Connect the 2 speed sensor connectors.
| 9. INSTALL STARTER ASSEMBLY |
![]() |
Install the starter assembly with the 2 bolts (1).
Connect the connector (2).
Connect the starter wire with the nut (3).
| 10. CONNECT WIRE HARNESS |
![]() |
Connect the wire harness with the bolt.
| 11. INSTALL WIRE HARNESS CLAMP |
![]() |
Install the 2 clamps and 3 bolts.
Connect the wire harnesses to the clamps.
| 12. INSTALL TRANSMISSION CONTROL CABLE CLAMP |
![]() |
Install the transmission control cable clamp with the bolt.
| 13. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH |
| 14. INSTALL FRONT DRIVE SHAFT ASSEMBLY RH |
| 15. INSTALL ENGINE ASSEMBLY WITH TRANSAXLE |
| 16. RESET MEMORY |