AUTOMATIC TRANSAXLE ASSEMBLY > REMOVAL |
| 1. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE |
| 2. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH |
| 3. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH |
| 4. REMOVE TRANSMISSION CONTROL CABLE CLAMP |
![]() |
Remove the bolt and the transmission control cable clamp.
| 5. REMOVE WIRE HARNESS CLAMP |
![]() |
Disconnect the wire harnesses from the clamp.
Remove the 3 bolts and 2 clamps.
| 6. DISCONNECT WIRE HARNESS |
![]() |
Remove the bolt and disconnect the wire harness.
| 7. REMOVE STARTER ASSEMBLY |
![]() |
Disconnect the connector (1).
Remove the nut (2) and disconnect the starter wire.
Remove the 2 bolts (3) and starter assembly.
| 8. DISCONNECT CONNECTORS |
![]() |
Disconnect the transmission wire connector.
Disconnect the park/neutral position switch connector.
Disconnect the 2 speed sensor connectors.
| 9. REMOVE TRANSMISSION CONTROL CABLE BRACKET NO.1 |
![]() |
Remove the bolt and automatic transmission oil cooler tube clamp.
Remove the 2 bolts and transmission control cable bracket No.1.
| 10. REMOVE TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY |
![]() |
Remove the ATF level gauge.
Disconnect the wire harnesses 2 clamps from the oil filler tube.
Remove the 2 bolts and oil filler tube.
Remove the O-ring from the oil filler tube.
| 11. REMOVE OIL COOLER INLET TUBE NO.1 |
![]() |
Using SST and a wrench, disconnect the oil cooler inlet tube No.1.
| 12. REMOVE OIL COOLER OUTLET TUBE NO.1 |
Using SST and a wrench, disconnect the oil cooler outlet tube No.1.
| 13. REMOVE ENGINE MOUNTING BRACKET FRONT |
![]() |
Remove the 3 bolts and engine mounting bracket front.
| 14. REMOVE AUTOMATIC TRANSAXLE ASSEMBLY |
![]() |
Remove the 2 bolts and flywheel housing under cover.
![]() |
Turn the crankshaft to gain access and remove the 6 bolts while holding the crankshaft pulley bolt with a wrench.
![]() |
Remove the 10 bolts.
Separate and remove the automatic transaxle.
| 15. REMOVE TORQUE CONVERTER CLUTCH ASSEMBLY |
| 16. INSPECT TORQUE CONVERTER CLUTCH ASSEMBLY |