Home › TRANSMISSION ยท U151F AUTOMATIC TRANSAXLE › AUTOMATIC TRANSAXLE ASSEMBLY

AUTOMATIC TRANSAXLE ASSEMBLY > REMOVAL

for Preparation Click here



1. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE

HINT:
(Click here)



2. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH

HINT:



3. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH

HINT:



4. REMOVE TRANSMISSION CONTROL CABLE CLAMP


    C083203
  1. Remove the bolt and the transmission control cable clamp.



5. REMOVE WIRE HARNESS CLAMP


    D030465
  1. Disconnect the wire harnesses from the clamp.

  1. Remove the 3 bolts and 2 clamps.



6. DISCONNECT WIRE HARNESS


    G025456
  1. Remove the bolt and disconnect the wire harness.



7. REMOVE STARTER ASSEMBLY


    D030464E02
  1. Disconnect the connector (1).

  1. Remove the nut (2) and disconnect the starter wire.

  1. Remove the 2 bolts (3) and starter assembly.



8. DISCONNECT CONNECTORS


    D030864E04
  1. Disconnect the transmission wire connector.

  1. Disconnect the park/neutral position switch connector.

  1. Disconnect the 2 speed sensor connectors.



9. REMOVE TRANSMISSION CONTROL CABLE BRACKET NO.1


    D030467
  1. Remove the bolt and automatic transmission oil cooler tube clamp.

  1. Remove the 2 bolts and transmission control cable bracket No.1.



10. REMOVE TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY


    D030468
  1. Remove the ATF level gauge.

  1. Disconnect the wire harnesses 2 clamps from the oil filler tube.

  1. Remove the 2 bolts and oil filler tube.

  1. Remove the O-ring from the oil filler tube.



11. REMOVE OIL COOLER INLET TUBE NO.1


    D030469E03
  1. Using SST and a wrench, disconnect the oil cooler inlet tube No.1.

    SST
    09023-12701  



12. REMOVE OIL COOLER OUTLET TUBE NO.1
  1. Using SST and a wrench, disconnect the oil cooler outlet tube No.1.

    SST
    09023-12701  



13. REMOVE ENGINE MOUNTING BRACKET FRONT


    D030470
  1. Remove the 3 bolts and engine mounting bracket front.



14. REMOVE TRANSFER STIFFENER PLATE RH


    D030512
  1. Remove the 5 bolts and transfer stiffener plate RH.



15. REMOVE AUTOMATIC TRANSAXLE W/TRANSFER


    D030471
  1. Remove the 2 bolts and flywheel housing under cover.



    D030472
  1. Turn the crankshaft to gain access and remove the 6 bolts while holding the crankshaft pulley bolt with a wrench.

    HINT:
    There will be one green colored bolt.



    C163047
  1. Remove the 10 bolts.

  1. Separate and remove the automatic transaxle w/transfer.



16. REMOVE TRANSFER ASSEMBLY

HINT:



17. REMOVE TORQUE CONVERTER CLUTCH ASSEMBLY


18. INSPECT TORQUE CONVERTER CLUTCH ASSEMBLY

HINT:
(Click here)