Home › CRUISE CONTROL SYSTEM › CRUISE CONTROL › DYNAMIC LASER CRUISE CONTROL SYSTEM

DTC    P0571    Brake Switch "A" Circuit

for Preparation Click here


DESCRIPTION

When the brake pedal is depressed, the stop light switch sends a signal to the ECM. When the ECM receives this signal, it cancels the cruise control. The fail-safe function operates to enable normal driving even if there is a malfunction in the stop light signal circuit. Cruise control cancellation occurs when voltage is applied to terminal STP. When the brake is applied, voltage is normally applied to terminal STP of the ECM through the STOP SW fuse and the stop light switch, and the ECM turns the cruise control off.

DTC No.
DTC Detection Condition
Trouble Area
P0571
Voltage of STP terminal and that of ST1- terminal of ECM are less than 1 V for 0.5 seconds or more
  1. Stop light switch
  2. Stop light switch circuit
  3. ECM

WIRING DIAGRAM


E144491E02


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (STOP LIGHT SWITCH - BATTERY)


    E173428E01
  1. Disconnect the stop light switch connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    S12-2 - Body ground
    Always
    10 to 14 V
    S12-3 - Body ground
    Ignition switch ON
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.INSPECT STOP LIGHT SWITCH


    E065594E60
  1. Remove the stop light switch.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 2
    Switch pin not pushed
    Below 1 Ω
    3 - 4
    Switch pin not pushed
    10 kΩ or higher
    1 - 2
    Switch pin pushed
    10 kΩ or higher
    3 - 4
    Switch pin pushed
    Below 1 Ω



NG
REPLACE STOP LIGHT SWITCH
OK


3.CHECK ECM


    E127020E05
  1. Reconnect the stop light switch connector.

  1. Disconnect the ECM connector.

  1. Turn the ignition switch to the ON position.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Brake Pedal Condition
    Specified Condition
    E4-15 (STP) - Body ground
    Depressed
    7.5 to 14 V
    E4-15 (STP) - Body ground
    Released
    Below 1.5 V
    E4-16 (ST1-) - Body ground
    Depressed
    Below 1.5 V
    E4-16 (ST1-) - Body ground
    Released
    7.5 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (STOP LIGHT SWITCH - ECM)
OK

REPLACE ECM (Click here)