DTC P0571 Brake Switch "A" Circuit |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0571 | Voltage of STP terminal and that of ST1- terminal of ECM are less than 1 V for 0.5 seconds or more. |
|

| 1.CHECK HARNESS AND CONNECTOR (STOP LIGHT SWITCH - BATTERY) |
![]() |
Disconnect the stop light switch connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| S12-2 - Body ground | Always | 10 to 14 V |
| S12-3 - Body ground | Ignition switch ON | 10 to 14 V |
|
| ||||
| OK | |
| 2.INSPECT STOP LIGHT SWITCH |
![]() |
Remove the stop light switch.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 1 - 2 | Switch pin not pushed | Below 1 Ω |
| 3 - 4 | Switch pin not pushed | 10 kΩ or higher |
| 1 - 2 | Switch pin pushed | 10 kΩ or higher |
| 3 - 4 | Switch pin pushed | Below 1 Ω |
Reinstall the stop light switch.
|
| ||||
| OK | |
| 3.CHECK ECM |
![]() |
Reconnect the stop light switch connector.
Disconnect the ECM connector.
Turn the ignition switch to ON.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Brake Pedal Condition | Specified Condition |
| E4-15 (STP) - Body ground | Depressed | 7.5 to 14 V |
| E4-15 (STP) - Body ground | Released | Below 1.5 V |
| E4-16 (ST1-) - Body ground | Depressed | Below 1.5 V |
| E4-16 (ST1-) - Body ground | Released | 7.5 to 14 V |
|
| ||||
| OK | ||
| ||