Home › BODY › SLIDING ROOF › SLIDING ROOF HOUSING

SLIDING ROOF HOUSING > INSTALLATION

for Preparation Click here



1. INSTALL SLIDING ROOF HOUSING ASSEMBLY
  1. Install the housing with the 6 nuts.

  1. Install the 4 brackets with the 8 bolts.

  1. Connect the 4 hoses and drive gear connector.



2. ADJUST SLIDING ROOF GLASS SUB-ASSEMBLY


    B068227
  1. Check for a difference in levels between the sliding roof (roof glass) and roof panel.

    Difference:
    0 +- 2.0 mm (0.072 in.)

    NOTICE:
    The clearance should be even all around.



3. INSTALL SLIDING ROOF GLASS SUB-ASSEMBLY
  1. Using a "TORX" socket wrench (T25), loosen the screw to adjust the sliding roof panel position. When the adjustment has been done, tighten the screw there.



4. RESET SLIDING ROOF POSITION


5. CHECK FOR WATER LEAKS
  1. Adjusting the sliding roof, check that there is no water leak.
    If a leak is found, readjust the sliding roof.



6. INSTALL ROOF HEADLINING ASSEMBLY

HINT:
Click here