Home › BODY ELECTRICAL › DOOR LOCK › KEY REMINDER WARNING SYSTEM

KEY REMINDER WARNING SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use these procedures to troubleshoot the key reminder warning system.
  2. The Techstream should be used in steps 3 and 5.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS

      NEXT


      3.INSPECT COMMUNICATION FUNCTION OF MULTIPLEX COMMUNICATION SYSTEM (BEAN)
      1. Use the Techstream to check if the Multiplex Communication System (MPX) is functioning normally.

        Result:
        Result
        Proceed to
        MPX DTC is not output
        A
        MPX DTC is output
        B



      B.
      GO TO MULTIPLEX COMMUNICATION SYSTEM
      A


      4.PROBLEM SYMPTOMS TABLE

        Result:

        Result
        Proceed to
        Fault is not listed on problem symptoms table
        A
        Fault is listed on problem symptoms table
        B



      B.
      After repair, go to step 7
      A


      5.OVERALL ANALYSIS AND TROUBLESHOOTING
      1. Terminals of ECU
        (Click here).

      2. Data List / Active Test
        (Click here).


      NEXT


      6.REPAIR OR REPLACE

        NEXT


        7.CONFIRMATION TEST

          NEXT

          END