Home › ENGINE › 2GR-FE ENGINE CONTROL SYSTEM › CRANKSHAFT POSITION SENSOR

CRANKSHAFT POSITION SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL CRANKSHAFT POSITION SENSOR
  1. Apply a light coat of engine oil to the O-ring on the crankshaft position sensor.



    A076417
  1. Install the crankshaft position sensor with the bolt.

    Torque:
    9.0 N*m{ 92 kgf*cm , 80 in.*lbf }

  1. Connect the crankshaft position sensor connector.



2. INSTALL COMPRESSOR AND MAGNETIC CLUTCH

HINT:
(Click here)