PARK / NEUTRAL POSITION SWITCH > INSTALLATION |
| 1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY |
![]() |
Install the park/neutral position switch to the manual valve shaft.
Temporarily install the 2 bolts.
![]() |
Place a new lock plate and tighten the nut.
Temporarily install the control shaft lever.
![]() |
Turn the lever counterclockwise until it stops, then turn it clockwise 2 notches.
Remove the control shaft lever.
![]() |
Align the groove with the neutral basic line.
Hold the switch in position and tighten the 2 bolts.
![]() |
Using a screwdriver, bend the tabs of the lock plate.
![]() |
Install the control shaft lever, washer and the nut.
![]() |
Connect the park/neutral position switch connector.
| 2. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY |
![]() |
Connect the control cable to the control shaft lever with the nut.
![]() |
Install the control cable with a new clip to the bracket.
| 3. ADJUST PARK/NEUTRAL POSITION SWITCH ASSEMBLY |
![]() |
Loosen the 2 bolts of the park/neutral position switch and move the shift lever to the N position.
Align the groove with the neutral basic line.
Hold the switch in position and tighten the 2 bolts.
After adjustment, perform the inspection described in park/neutral position switch assembly operation.
| 4. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY OPERATION |
Apply the parking brake and turn the ignition switch to the ON position.
Depress the brake pedal and check that the engine starts only when the shift lever is in the N or P position and the engine does not start when the shift lever is in other positions.
Check that the back up light comes on and the reverse warning buzzer sounds only when the shift lever is in the R position and the light and buzzer do not operate when the shift lever is in other positions.
If a failure is found, check the park/neutral position switch for continuity.
| 5. INSPECT SHIFT LEVER POSITION |
When shifting from P to R position only with ignition switch ON and brake pedal, make sure that the shifting lever moves smoothly and can be moderately operated.
When starting engine, make sure that the vehicle moves forward when shifting from N to D position and moves rearward when shifting to R position.
| 6. ADJUST SHIFT LEVER POSITION |
![]() |
Loosen the nut on the control shaft lever.
![]() |
Push the control shaft fully downward.
Return the control shaft lever 2 notches to the N position.
![]() |
While pushing the control cable end up with the shift lever in the N position, install it to the control shaft lever with the nut.
Start the engine and make sure that the vehicle moves forward when shifting the lever from the N to D position and moves rearward when shifting it to the R position.
| 7. INSTALL AIR CLEANER ASSEMBLY |
| 8. INSTALL BATTERY |