Home › TRANSMISSION ยท U151F AUTOMATIC TRANSAXLE › DIFFERENTIAL OIL SEAL

DIFFERENTIAL OIL SEAL > INSTALLATION

for Preparation Click here



1. INSTALL DIFFERENTIAL SIDE BEARING RETAINER OIL SEAL


    C083053E01
  1. Using SST and a hammer, install a new oil seal.

    SST
    09223-15020  
    09950-70010   (09951-07200)

    Oil seal installation depth:
    -0.5 to 0.5 mm (-0.020 to 0.020 in.)

  1. Coat the lip of the oil seal with MP grease.



2. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH

HINT:



3. INSTALL FRONT WHEELS

Torque:
103 N*m{ 1,050 kgf*cm , 76 ft.*lbf }



4. ADD AUTOMATIC TRANSAXLE FLUID


5. INSPECT AUTOMATIC TRANSAXLE FLUID

HINT:
Drive the vehicle so that the engine and transaxle are at normal operating temperature.

Fluid temperature:
70 to 80°C (158 to 176°F)

  1. Park the vehicle on a level surface and set the parking brake.



    D025120E05
  1. With the engine idling and the brake pedal depressed, move the shift lever to all positions from P to L and return to the P position.

  1. Take out the dipstick and wipe it clean.

  1. Put the dipstick back all the way.

  1. Take out the dipstick again and check that the fluid level is within the HOT range.
    If the fluid level is below the HOT range, add new fluid and recheck the fluid level.
    If the fluid level exceeds the HOT range, drain the fluid once, add the proper amount of new fluid and recheck the fluid level.
    If there are leaks, it is necessary to repair or replace O-rings, FIPGs, oil seals, plugs and/or other parts.



6. INSTALL ENGINE UNDER COVER NO.1


7. CHECK ABS SPEED SENSOR SIGNAL

HINT:
(Click here)



8. INSTALL TRANSAXLE HOUSING OIL SEAL


    D030913E01
  1. Using SST and a hammer, install a new oil seal.

    SST
    09649-17010  
    09950-70010   (09951-07200)

    Oil seal installation depth:
    5.5 to 6.5 mm (0.217 to 0.256 in.)

  1. Coat the lip of the oil seal with MP grease.



9. INSTALL TRANSFER ASSEMBLY

HINT:



10. INSTALL AUTOMATIC TRANSAXLE W/TRANSFER

HINT:



11. INSTALL FRONT DRIVE SHAFT ASSEMBLY RH (for 4WD)

HINT:



12. INSTALL TRANSFER STIFFENER PLATE RH

HINT:



13. INSTALL ENGINE ASSEMBLY WITH TRANSAXLE

HINT:
(Click here)