Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM

DTC    01-DC    Transmission Error

for Preparation Click here


DESCRIPTION


DTC No.
DTC Detection Condition
Trouble Area
01-DC
*1
Transmission to component shown by sub-code failed.
(Detecting this DTC does not always mean actual failure.)
If the same sub-code is recorded in other components, check harness for power supply and communication system of all components shown by code

HINT:
*1: This code may be stored if the engine is started, idled for 60 seconds and then the ignition switch is turned to the START position again.

NOTICE:
  1. Before starting troubleshooting, be sure to clear DTCs to erase codes stored due to the reasons described in the HINT above. Then, check for DTCs and troubleshoot according to the output DTCs.
  2. The navigation receiver assembly is the master unit.
  3. Be sure to clear and recheck DTCs after the inspection is completed to confirm that no DTCs are output.


INSPECTION PROCEDURE

NOTICE:
Be sure to read DESCRIPTION before performing the following procedures.

1.CHECK FOR DTC OF OTHER COMPONENTS
  1. Check if the component shown by the sub-code is displayed in the check result of the other components.

    1. Check if "01-DC" is output for the other components.

    2. If "01-DC" is output for any other components, check if the same physical address is displayed.

      HINT:
      For the list of the components shown by sub-codes, refer to the table in step 2.

      Result:
      Result
      Proceed to
      "01-DC" is output and the same physical address is displayed
      A
      "01-DC" is not output or the same physical address is not displayed
      B



B
Go to step 4
A


2.IDENTIFY THE COMPONENT WHICH HAS STORED THIS CODE


    E121199E02
  1. Enter the diagnostic mode.

  1. Press the "LAN Mon" switch to change to "LAN Monitor" mode.

  1. Identify the component which has stored this code.
    Component Table: 
    Display
    Component
    Rr-TV (1B0)
    Television display assembly
    DSP-AMP (440)
    Stereo component amplifier
    AVN (140)
    Navigation receiver assembly

    HINT:
    "NAVI" is the component which has stored this code in the example shown in the illustration.


NEXT


3.CHECK COMPONENT WHICH HAS STORED THIS CODE
  1. Select the component which has stored this code.

    Component Table: 
    Component
    Proceed to
    Navigation receiver assembly (AVN)
    Navigation receiver assembly communication error (Click here)
    Television display assembly (Rr-TV)
    Television display assembly communication error (Click here)
    Stereo component amplifier (DSP-AMP)
    Stereo component amplifier communication error (Click here)


NEXT

END 

4.CLEAR DTC
  1. Clear the DTCs (Click here).

    HINT:
    If "01-DC" is output for only one component, this may not indicate a malfunction.


NEXT


5.RECHECK DTC
  1. Recheck for DTCs and check if the same trouble occurs again.

OK:
Malfunction disappears.



NG
Go to step 3
OK

END