Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM

NAVIGATION SYSTEM > Television Display Assembly Communication Error

for Preparation Click here


INSPECTION PROCEDURE

1.IDENTIFY THE COMPONENT SHOWN BY THE SUB-CODE


    E121199E01
  1. Enter the diagnostic mode.

  1. Press the "LAN Mon" switch to change to "LAN Monitor" mode.

  1. Identify the component shown by the sub-code.

    HINT:
    1. "110 (multi-display)" is the component shown by the sub-code in the example shown in the illustration.
    2. The sub-code will be indicated by its physical address.
    3. For the component list, refer to "DIAGNOSIS DISPLAY DETAILED DESCRIPTION" (Click here).


NEXT


2.CHECK POWER SOURCE CIRCUIT OF COMPONENT SHOWN BY SUB-CODE
  1. Inspect the power source circuit of the component shown by the sub-code.
    If the power source circuit is operating normally, proceed to the next step.

    Component Table: 
    Component
    Proceed to
    Navigation receiver assembly (140)
    Navigation receiver assembly power source circuit (Click here)
    Stereo component amplifier (440)
    Stereo component amplifier power source circuit (Click here)


NEXT


3.INSPECT NAVIGATION RECEIVER ASSEMBLY


    E120086E01
  1. Disconnect the navigation receiver assembly connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester connection
    Condition
    Specified condition
    ATX+ (R15-5) - ATX- (R15-15)
    Always
    60 to 80 Ω
    TXM+ (R14-9) - TXM- (R14-10)
    Always
    60 to 80 Ω



NG
REPLACE NAVIGATION RECEIVER ASSEMBLY
OK


4.CHECK HARNESS AND CONNECTOR

HINT:
  1. Start the check from the circuit that is near the component shown by the sub-code first.
  2. For details of the connectors, refer to "TERMINALS OF ECU" (Click here).



  1. Referring to the AVC-LAN wiring diagram below, check the AVC-LAN circuit between the television display assembly and the component shown by the sub-code.

    1. Disconnect all connectors between the television display assembly and the component shown by sub-code.



    2. Check for an open or short in the AVC-LAN circuit between the television display assembly and the component shown by the sub-code.


      E120087E04

      OK:
      There is no open or short circuit.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5.REPLACE COMPONENT SHOWN BY SUB-CODE
  1. Replace the component shown by the sub-code with a normal one and check if the same problem occurs again.

    OK:
    Same problem does not occur.



NG
REPLACE TELEVISION DISPLAY ASSEMBLY
OK

END