Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM

DTC    01-DD    Master Reset

DTC    01-E1    Voice Processing Device ON Error

for Preparation Click here


DESCRIPTION


DTC No.
DTC Detection Condition
Trouble Area
01-DD
*1
The device that should be the master has been disconnected after the engine starts.
  1. Navigation receiver assembly power source circuit
  1. AVC-LAN circuit between the navigation receiver assembly and the component which has stored this code
  1. Navigation receiver assembly
  1. Component which has stored this code
01-E1
*2
The AMP device records that the AMP output does not function even while the source device is operating.

HINT:
  1. *1: This code may be stored if the engine is started and the ignition switch is turned to the START position again.
  2. *2: Even if no fault is present, this trouble code may be stored depending on the battery condition or engine start voltage.

NOTICE:
  1. Before starting troubleshooting, be sure to clear DTCs to erase codes stored due to the reasons described in the HINT above. Then, check for DTCs and troubleshoot according to the output DTCs.
  2. The navigation receiver assembly is the master unit.
  3. Be sure to clear and recheck DTCs after the inspection is completed to confirm that no DTCs are output.


INSPECTION PROCEDURE

NOTICE:
Be sure to read DESCRIPTION before performing the following procedures.

1.CHECK NAVIGATION RECEIVER ASSEMBLY POWER SOURCE CIRCUIT
Refer to the navigation receiver assembly power source circuit (Click here).
If the power source circuit is operating normally, proceed to the next step.

NEXT


2.INSPECT NAVIGATION RECEIVER ASSEMBLY


    E120086E01
  1. Disconnect the navigation receiver assembly connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    ATX+ (R15-5) -
    ATX- (R15-15)
    Always
    60 to 80 Ω
    TXM+ (R14-9) -
    TXM- (R14-10)
    Always
    60 to 80 Ω



NG
REPLACE NAVIGATION RECEIVER ASSEMBLY
OK


3.IDENTIFY THE COMPONENT WHICH HAS STORED THIS CODE


    E111829E03
  1. Enter the diagnostic mode.

  1. Press the "LAN Mon" switch to change to "LAN Monitor" mode.

  1. Identify the component which has stored this code.
    Component Table: 
    Display
    Component
    Rr-TV
    Television display assembly
    DSP-AMP
    Stereo component amplifier

    HINT:
    "NAVI" is the component which has stored this code in the example shown in the illustration.


NEXT


4.CHECK HARNESS AND CONNECTOR

HINT:
For details of the connectors, refer to "TERMINALS OF ECU" (Click here).



  1. Referring to the AVC-LAN wiring diagram below, check the AVC-LAN circuit between the navigation receiver assembly and the component which has stored this code.

    1. Disconnect all connectors between the navigation receiver assembly and the component which has stored this code.



    2. Check for an open or short in the AVC-LAN circuit between the navigation receiver assembly and the component which has stored this code.

      OK:
      There is no open or short circuit.


      E120087E04



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5.REPLACE NAVIGATION RECEIVER ASSEMBLY
  1. Replace the navigation receiver assembly with a normal one and check if the same problem occurs again.

    OK:
    Same problem does not occur.



NG
REPLACE COMPONENT WHICH HAS STORED THIS CODE
OK

END